Kloxo no_ip_address解决方法：VPS 添加多IP设置

Linode VPS默认情况下是通过DHCP自动获取IP的，所以在安装Kloxo完成设置Kloxo的时候会出现no_ip_address的提示，这个时候就需要手动设置上IP，这样才能添加域名。
如果你设置Kloxo的时候出现no_ip_address的提示你可以按照下面步骤修改：
使用编辑器编辑（如果不会用编辑器，可以使用winscp）：/etc/sysconfig/network-scripts/ifcfg-eth0
# Configuration for eth0
DEVICE=eth0
BOOTPROTO=none
# This line ensures that the interface will be brought up during boot.
ONBOOT=yes
# eth0 – This is the main IP address.
# The address, netmask and gateway are all necessary.
IPADDR=12.34.56.78   #你的IP地址
NETMASK=255.255.255.0  #子网掩码
GATEWAY=12.34.56.1 #网关
一般这样设置好，再执行命令：service network restart 重启网络就好了，如果还是不通，重启试一下。
添加第2个IP，可以创建 /etc/sysconfig/network-scripts/ifcfg-eth0:0
# Configuration for eth0:0
DEVICE=eth0:0
BOOTPROTO=none
# This line ensures that the interface will be brought up during boot.
ONBOOT=yes
# eth0:0
IPADDR=34.56.78.90
NETMASK=255.255.255.0
GATEWAY=12.34.56.1
添加第3个IP，创建 /etc/sysconfig/network-scripts/ifcfg-eth0:1 按上面的内容添加到这个文件中，以此类推。
以上办法都是在CentOS或者Fedora下添加IP的方法，如果是在Debian/Ubuntu下添加IP的方法(注，当然Kloxo没有Debian下的版本)：
修改 /etc/network/interfaces
# The loopback interface
auto lo
iface lo inet loopback
# Configuration for eth0 and aliases
# This line ensures that the interface will be brought up during boot.
auto eth0 eth0:0 eth0:1
# eth0 – This is the main IP address that will be used for most outbound connections.
# The address, netmask and gateway are all necessary.
iface eth0 inet static
address 12.34.56.78
netmask 255.255.255.0
gateway 12.34.56.1
# eth0:0
iface eth0:0 inet static
address 34.56.78.90
netmask 255.255.255.0
# eth0:1 – Private IPs have no gateway (they are not publicly routable) so all you need to
# specify is the address and netmask.
iface eth0:1 inet static
address 192.168.133.234
netmask 255.255.128.0
保存重启网络，/etc/init.d/networking restart 即可。